12
OPERATION
Control panel
Upon connecting the plate to the mains a short sound should be emitted, after which you
can operate the plate!
Caution! Do not put any objects on the area of the sensors (a fault can be trigged),
always keep them clean.
Switching on the ceramic plate
If the plate is not in operation, all the hotplates are switched off and the display is blank. When
you touch the main sensor (1), the plate switches on and all the hotplate indicators (3) show
“0” for about 10 seconds. You can now set the required heating power by touching sensors
“+” (5) or “-“ (4) having previously selected a hotplate by touching sensor (2) (see Setting up
the heating power).
Should you fail to activate any sensor within 10 seconds, the plate will switch off au-
tomatically
If the children lock is active the plate cannot be switched on (see Unlocking the
plate).
Switching on a hotplate
After switching on the plate with the main sensor (1) the individual hotplates are set in the
following manner:
1. Select the desired hotplate with appropriate hotplate selection sensor (2).
The assignment of sensors to the respective hotplates corresponds with the
hotplates’ layout.
2. Set the required heating power by touching sensors „+” (5) or „-”(4).
3. To change the set heating power, proceed as in point 1, so first select the de
-
sired hotplate with appropriate hotplate selection sensor (2) and then adjust
the heating power with „+” (5) or „-” (4) sensors
Should you fail to activate any sensor within 10 seconds from switching on the plate,
the hotplate will switch off .
A hotplate is active when the indicated figure flashes, meaning that the hotplate is ready
to set the heating power.