![background image](http://html1.mh-extra.com/html/amica/ebsx-949-600-e/ebsx-949-600-e_instruction-manual_2932721024.webp)
24
OPERATION
NOTE: When water runs out the programme
is not interrupted!
When the set time has elapsed, you will
hear beeping. Touch any sensor to mute the
beeping.
Touch OK acknowledge the completed pro-
gramme. The message “Remove water” will
be show on the display.
Open the door ajar to the first position (about
15°).
You can open the door all the way after a
few seconds.
Then place deep baking tray under the water
drain.
Press OK to drain the remaining water from
steam system.
Wipe oven cavity dry with a cloth.
When you have run steam programmes
several times, start the oven fan heater for
30 minutes at 180°C.
NOTE: Danger of burns! Hot steam may
escape when you open the oven door. Be
careful when you open the oven door during
or after cooking. Do NOT lean over the door
when you open it. Please note that depend-
ing on the temperature the steam can be
invisible.
IMPORTANT: Ensure there is no water in
the steam system when you use standard
heating functions. Do not add water into the
container drawer when using the standard
heating functions.
Descale the steam system
When you have run several steam pro-
grammes, a flashing “Descale” message
will be shown on the display. This message
prompts you to descale the system. You can
skip descaling twice, by touching the sen-
sor. However, eventually the appliance will
not allow you to run a steam programmes
again until you descale the appliance.
When you select the “Descale” programme,
the display will show the message “Add 0.5l
of descaling agent.” During the program, you
will see the messages “Add 0.5l of water” and
“Remove water” (rinsing).
Descale the appliance.
•
Prepare the solution of 450 ml of water
and 50 ml of liquid descaling agent.
•
Pour the solution into the water con-
tainer drawer.
•
Press OK to start the “Descale” pro-
gramme.
NOTE: During the descaling programme,
you will need to drain water from the steam
system 3 times.
Drain the descaling solution from the system
when you hear a beep and the “Remove
water” message is flashing.
•
Open the oven door.
•
Then place deep baking tray under the
water drain.
•
Press OK to drain the remaining des-
caling solution from the steam system.
Pour the solution out of the baking tray
and rinse it with water.
Add water when you hear beeping and the
message “Add water” is flashing on the dis
-
play. To rinse the steam system, pour 0.5 l of
clean water into the water container drawer
and touch OK to continue the programme.