14
DESCRIPTION OF THE APPLIANCE
Appliance components (regarding to photo on page 7):
1. Handle
2. Power control slider in handle
3.
Telescopic tube
4. Hose
5. Vacuum cleaner handle
6.
Power smooth control knob
7. Cover lock
8. Dust container
9. Hose socket
10. Cord retractor button
11. Power button
12. Brush
Preparing for vacuuming
Always unplug the appliance before attaching or removing attachments!
l
Attaching flexible hose: insert the hose end into the inlet port. Push until the end falls into place with
an audible click (Fig. 2, item 1).
l
Removing the hose: press buttons on the hose end, unlatch and remove the hose from the inlet port
(Fig. 2, item 2).
l
Connect the telescopic tube with the hose (Fig. 2, item 3) and the proper attachment (Fig. 2, item 4),
slide open the telescopic tube to a suitable length.
l
Grab the plug and pull the power cord while holding the appliance body, plug into a power outlet.
l
Before you start vacuuming, extend power cord cable to sufficient length and insert the plug into the
wall socket (Fig. 2, item 5). The yellow mark on the power cord indicates it is extended almost all the
way. When you see the red mark do not pull the power cord any further.
l
Switch on the appliance with the on / off button. (Fig. 2, item 6a).
l
After finishing using the appliance, press the on/off button to turn off the vacuum cleaner (Fig. 2, item
6a).
l
Unplug the cord from the wall outlet.
l
Retract the power cord by pressing cord retractor button (Fig. 2, item 9). For this operation hold the
cord to prevent it from tangling or bumping the plug on the vacuum cleaner housing.
l
Disconnect the suction cleaning head from the tube and disconnect the telescopic tube from the
hose.
l
Close the telescopic tube.
The vacuum cleaner may be stored in a vertical or horizontal position. The hose can remain attached to
the vacuum cleaner, but please be careful not to bend it too much during storage.
