25
OPERATION
Follow the same procedure to adjust KITCH
-
EN TIMER time.
Duration.
You can program the appliance to turn off
after 00:01h to 10:00h (with an accuracy of
1 minute), as if you set
function selector
knob
to
0
. When you set DURATION, the
ECO function is also active (as described in
ECO function section), which is indicated by
the
symbol.
Activate DURATION.
Set Function Selector Knob to any function
(other than
0
) to be able to set DURATION.
Touch and hold
(you will hear a [confirma
-
tion] beep) until
starts flashing and the
main time display shows flashing 00:00. Use
setting selection knob
to set DURATION.
Touch
to confirm. You will hear a [con
-
firmation] beep. The
will stop flashing.
The display shows flashing indication: [cur
-
rent time + DU 1 minute]. Touch
again to activate DURATION. If you do
nothing for 5 seconds, the function activates
automatically.
You will hear [end] beep when DURATION
is set.
When DURATION starts the main time dis-
play shows current time and
symbol is
shown. The oven turns on. The remaining
duration is counted down as shown below.
Set
function selector knob
to
0
to cancel
DURATION.
Follow the same procedure to adjust DURA
-
TION time.
End duration function
When duration has elapsed the oven turns off
as if you set
function selector knob
to
0
. You
will hear [end time] beep for about 1 minute.
The
symbol and time indication 00:00
are flashing until you set
function selector
knob
to
0
. When DURATION has elapsed
you will not be able to use any other function
until you first set
function selector knob
to
0
.
When DURATION has elapsed you can use
the oven with the same settings. Touch
and set DURATION again.
Touch any control to silence the alarm.
Delay start.
You can delay start of the oven and set the
End Time as needed. Based on the End
Time and Duration the appliance automati-
cally calculates Start Time. The appliance
will automatically turn on and off. End Time
can be set from [current time] to 23h 59min
and Duration up to 10h with an accuracy of
one minute.
To set DELAY START function, first set DU
-
RATION.
Activate DURATION. Touch
to confirm
DURATION and
stop flashing and
starts flashing. [current time + DURATION
+1min] is flashing on the display. Use
set-
ting selection knob
to set End Time. Touch
or do nothing for 5 seconds to confirm.
DELAY START function is activates and you
will hear [end] beep.
Once DELAY START is activated the main
time display show current time. The
and
symbols are on. The appliance counts
downs the time remaining to start based on
set End Time and Duration. When the oven
starts the
symbol goes out and there is
a countdown to End Time.
