Amibot Spirit ICE, User Manual

Page: 14 / 96

24 25
Maintenance Maintenance
EN EN
H2O tank
Empty the dust collected during the cleaning cycle and remaining
water from the H2O tank and then rinse it with clean water. Wait
until it is dry before using it again.
Regularly check that the H2O tank's two drip nozzles are not
obstructed by debris or limescale. Clean them with a soft cloth.
Filters
Access the filters directly from the dust bin. Once the prefilter has
opened in two, gently pull on the prefilter’s two handles.
1. The prefilter may contain dust, shake it to clean it. Run under
clean water to remove any remaining dust that has built up. Wait
until it is fully dry before putting it back.
2. The HEPA filter cannot be cleaned, otherwise it would become
damaged. To extend the filter's life, gently shake it outside to
remove any small dust particles that could accumulate. If the
HEPA filter is damaged, you are recommended to replace it to
ensure that your robot's filter performance is maintained.
3. The protection filter must be cleaned with clean water to remove
all the built up dust. Wait until it is fully dry before putting it back.
1
2
3
Gap and power sensors
The gap and power sensors on
the bottom of the robot and on
the home base must be regularly
cleaned with a soft cloth. Never
let the sensors get wet.