25
Illustration of hydraulic valve for hydraulic power unit
V
. TEST RUN
1. Adjust synchronous cable
(See Fig. 34)
Push button “
UP”
to lift the carriages up to the position of the cable nut higher than
chain pulley. Use wrench to hold the cable fitting, meanwhile
use ratchet spanner to tighten the cable nut.
Make sure two cables are with the same tension
so that two carriage can work synchronously.
Fit the plastic hole cover on the lifting head.
If the carriage does not Synchronize when lifting,
please tighten the cable nut of lower side carriage.
2. Adjust safety cable
Lifting the carriage and lock at the same height, strain the safety cable and then
release a little, and then tighten the cable nuts. Make sure the safety device can
always be worked properly.
Fig. 34
Cable Nut
Fig.33
Check
valve
Oil return
port
Release
valve
Handle for
release valve
Protective
ring
Relief
valve
Throttle
valve
Oil outlet port
Summary of Contents for BP-10
