36
VI. OPERATION INSTRUCTIONS
A.
To lift vehicle
1
、
Keep work area clean around and near the lift;
2
、
Drive vehicle to the Platform and put on the brake;
3
、
Take off the drive-in ramp and install rear wheel stop plates to the drive-in ramp position.
4
、
Turn on the power source switch , press button
UP
and rise the lift to the working
position.
Note: when the lift is rising make sure the vehicle is steady.
5
、
Press button
Down
, lock the lift on the safety ladder and make sure the lift is locked on
the same position on the ladder before start to work.
B. To lower vehicle
1. Be sure the clearance of around and under the
lift, only leaving operator in lift area;
2. Press button
UP
, and rise the lift for 3-5 seconds, then pull down the safety release
handle, make sure the safety device released, and then keep pressing the safety release
handle by one hand and press button
Down
by another hand, the lift will fall down slowly.
The lift will be stopped automatically when coming down to about 400 mm to ground.
Check around and make sure it is safety and no any obstacle under the lift, then push both
DOWN
and
Lowering alarm button K
(the one on the side) at the same time, the lift
would be lowered with the tone alarm;
3. After the lift lower to the lowest position, take off the rear stop plate, install the drive-in
ramp and drive away the vehicle.
4. Turn off the power source
.
Fig.55
Power switch
Alarm
Power indicator
Button UP
Lowering
alarm button K
Button Down
