9
F. Install columns
Lay down two columns on the installation site parallelly, position the power-side
column according to the actual installation site. Usually, it is suggested to install
power-side column on the right of vehicles driven-in. This lift is designed with
2-section columns. Adjustable height according to the ceiling height and connecting
the inner and extension columns.
If the ceiling height is over
198 1/4”(5035mm)
, it can be installed in a high setting; if
the ceiling height between
174 3/8”(4430mm)-198 1/4”(5035mm)
, it can be installed
in the low setting; it is not allowed to install if the ceiling height less than
174 3/8”(4430mm)
.
1. High Setting, connecting the extension columns with the lower hole
(See Fig. 18)
.
Fig.
17
Fig.
18 High Setting
The fitting of the cylinder
toward the hole
Seal tape
Assemble the
cylinder into the
column
95
23
21
22
Summary of Contents for OH-12
