AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Page 4 of 8
AMG5611 Instruction Sheet
D17077-01.doc
Connections
Video Input Connections
No. of channels ....................................1
Connector ............................................75 ohm BNC Socket.
Input Impedance ..................................75 ohm terminated.
Input Level ...........................................1 volt p-p nominal
Frequency Response...........................10Hz to 7MHz.
Optical Connections
OPTO OUT / IN
Connector ............................................SC/PC
Primary Optical Launch Power ............-15dBm
Transmit Wavelength...........................1310nm
Optical Fibre ........................................Multimode 50/125 or 62.5/125**
**Note: the transmission distance is limited by the bandwidth of the Multimode optical fibre. The optical
data rate is 155Mbits/s, which may restrict operation to a maximum fibre length of 7km, although in
most cases the units will operate successfully over longer fibre lengths. It is advisable however for
distances greater than 7km, to have the optical fibre tested.
Power Connection
Connector Type ...................................Removable 2-pin, 3.81mm, Screw Terminal
Connector Partno.................................Phoenix 1803578
Supply Voltage.....................................12 to 24 Volts AC/DC
Maximum Power ..................................1.5 Watts
Front Panel Indicators
Power LED Video only
Power / Video / Opto............................Green
-
Video input.
Red
-
Unit powered, no Video input.
Off
-
No power applied to unit
