Door / Window Contacts (ST-Transmitter)
Sensors ordered in sets are shipped already paired.
The ST transmitter is used exclusively as a door window contact.
Please clean the surfaces with spirit or glass cleaner. The sensors are attached
using an adhesive pad.
The ST transmitter is turned on by pressing the
bottom large button
(
Nr. 6
) for 3-4 seconds.
To send a test signal, press the button once briefly.
To turn off the sensor, the blue backlight must be turned on using the
right button
(
Nr. 5
), then
press
the bottom large button
(
Nr. 6
) for 4 seconds. Note: The ST transmitter can only be
switched off if the blue display illumination with the right button has been switched on
beforehand.
To perform a
reset
, you must first activate the screen (
right
button
(
Nr. 5
)). Then press
the
left button
(
Nr. 4
) so that the small symbol at the top of the display flashes. Then
press twice the
right button
(
Nr. 5
) twice to get to the sun symbol (
pairing mode
).
If you press the button to fast you may land at another symbol. Just press the right button
until you reach the sun symbol. Confirm this with the
left button
(
Nr. 4
).
Note: Change the mode only if you need to re-pair a sensor.
