BWM-01 and BWM-02
Sensors ordered in sets are shipped already paired.
Please clean the surfaces with spirit or glass cleaner. The sensors are attached
using an adhesive pad.
To turn on the detector, press and hold the large right button on the front panel for about
4 seconds. Then slide the recessed switch on the top to the red dot to turn on the motion
detector board.
The motion detector is used to monitor rooms. Please note that the motion detector has a
fixed delay of approx. 60 seconds.
This means that the motion detector does not activate until about 60 seconds after
the last movement has been detected.
The sensor has a 180 degree lens and a detection range of about 10 meters. The sensor
is available in 2 versions: as a wide-angle version and as a pet version.
In the pet version, the sensor area is controlled so that there is a kind of light barrier
effect. In the free space under the sensor beam, the pet can move freely without
triggering an alarm.
Please observe the installation instructions for motion detectors. The test mode is
recommended.
Mount the motion detector in such a way that the probable direction of movement passes
the side of the motion detector. A person passing by the motion detector triggers the
alarm better than a person walking straight to the motion detector.
For motion detectors without pet function, a mounting height of approx. 200 cm from the
ground is recommended, the lower the sensor is mounted above the ground, the greater
the creep resistance. This refers to the area directly along the wall, which a burglar would
crawl back to get past the motion detector unrecognized.
