AMF S 4000 LS, Parts And Service Manual, Page: 51 / 76

S-4000 TKF, LS Omron
1-45
Released 12/2009
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
E - MACHINE ADJUSTMENTS
1 8 . A D J U S T M E N T O F T H E S T O P P I N G S E N S O R P O S I T I O N
Follow the steps described below to set the position of the sensor.
1. Put machine in the service mode (see E2).
2. Turn the handwheel counter clockwise until the stop disk finger
➊
is perpendicular to the sensor
➋
.
3. Loosen the screws
➌
and move the sensor bracket
➍
to the right. Tighten the screws
➌
.
4. Loosen M3 screw
➎
and adjust the sensor position so that the stop disk finger
➊
is in the center of the
sensor mark
➏
. The red LED
➐
illuminates on the sensor.
5. Tighten the M3 screw
➎
.
6. Return the machine head back to the working position.
7. Push the F6 key on the control panel and switch the machine to the working mode.
8. Start the machine and check the correct stopping of the machine. The needle bar must stop in
the home (upper) position.
www.promelectroavtomat.ru