ATX
6
25
(1) Enter the function menu and use “(
-
)” or “(+)” button to access AUX function.
(2) Press “Enter” button to get into CH3, CH4, CH5 or CH6 function interface.
(3) Use “(
-
)” or “(+)” button to select
Channel setup item.
Use “(
-
)” or “(+)” button to select POSI, press
“Enter”
key and the value will blink, use “(
-
)” or “(+)” button to
select “VR” or “SW”.
Press “Enter” button, the adjusted value stops blinking, now the value has been set
.
If you use the ATX6 to control RC Crawler, you can setup each channel as below.
CH1 is Steering
CH2 is Throttle
CH3 can setup to control the transfer case
CH4 can setup to control the shift gear
CH5 can Setup to control the front locker
CH6 can Setup to control the rear locker
4.18 Model N
ame „NAME“
ATX6 stores model memories for ten models. Each model memory
can be named separately according to user’s requirement.
Factory default name: MODEL1
(1) Enter the function menu and use “(
-
)” or “(+)” button to access
NAME function.
(2) Press “Enter” button to get into NAME function interface, the first
character of current name will blink, and the blinking character can be
reset. The common use characters appear at the bottom of the
screen, use “(
-
)” or “(+)” button
to choose the character you desired.
Press
“Enter” button again, the next character of current name will
blink. Reset other characters of current name in same manner.
(3) After accomplishment of naming, all characters of current name will stop blinking, the new name will be
stored automatically.
(4) When ending setting, return to the initial screen by pressing
“Exit”
button twice. (the new setting model
name will appear on the initial screen).
4.19 Low Voltage Alarm
The transmitter’s low voltage alarm adjustable, it depends on what
kind of battery, the 4.6V is may cause the battery over discharge and
damage the battery. So, you can set transmitter’s warning voltage
when you use different battery.
There are four options you can choose:
Li2S-7.4V
Li3-11.1V
Ni4S-4.6V
ALARM: adjustable 4.0V to 16.0V
