ATX
6
17
A.B.S. Function adjustment
Enter the function menu and use “(
-
)” or “(+)” button to
access A.B.S function, then press “Enter” button to
get into A.B.S function interface.
(1) Brake return amount
adjustment Select the setting item "ABP" by pressing “(
-
)” or “(+)” button, then
press “Enter” key and the
initial value of
“ABP”
will blink. Use
“(
-
)”
or
“(+)” button
to adjust the return
amount. (Note: In the interface of adjusting the value, return to the initial value "50" by
pressing “(
-
)” and
“(+)” buttons simultaneously for about 1 second.)
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
Brake return amount (ABP)
0 ~ 50 ~ 100
Initial value: 50
Brake return amount (ABP) is influenced by the "EXP" rate on the brake side.
(2) Delay amount setup Select the setting item "DLY" by pressing “(
-
)” or “(+)” button, then press “Enter” key
and the initial value of
“DLY”
will blink. Use
“(
-
)”
or
“(+)”
button to adjust the delay amount. (Note: In the
interface of adjusting the value, return to the initial value "0" by pressing “(
-
)” and “(+)” buttons
simultaneously for about 1 second.) Press “Enter” button, the adjusted value stops blinking, now the value
has been set. "0": A.B.S. function performed without any delay "50": A.B.S function performed after an
approximate 0.7 sec delay "100": A.B.S. function performed after an approximate 1.7 secs delay
Delay amount (DLY)
0 ~ 100
Initial value: 0
(3) Pulse speed adjustment
Select setting item "CYC"
by pressing “(
-
)” or “(+)” button, then press “Enter” key
and the initial value of
“CYC”
will blink. Use
“(
-
)”
or
“(+)” button
to adjust the pulse speed (cycle). (Note: In the interface of
adjusting the value, return to the initial value "5" by pressing
“(
-
)” and “(+)” buttons simultaneously for about
1 second.) Press “Enter” button, the adjusted value stops blinking, now the value has been set.
- The smaller the set value, the faster the pulse speed.
Cycle Speed (CYC)
0 ~ 30
Initial value: 5
(4) Operation Point Setup
Select setting item "TGP" by pressing “(
-
)” or “(+)” button, then press “Enter” key and the initial value
of
“TGP” will
blink. Use “(
-
)” or “(+)”
button to adjust the operation point. (Note: In the interface of adjusting the
value, return to the initial value "30" by
pressing “(
-
)” and “(+)” buttons simultaneously for about 1 second.)
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
- Sets the throttle
trigger position at which the A.B.S. function is performed. The number is the 100 display with the full brake
position made 100%.
Operation point (TGP)
0 ~ 100
Initial value: 30
