BEDIENUNGSANLEITUNG/MANUAL BINARY V2
25
TRANSMITTER
Install the control levers as show on picture.
Install batteries:
Please use new AA Mignon batteries for the transmitter.
1.
Ensure transmitter POWER switch is in off position.
2.
Slide off the battery door on the back of the transmitter.
3.
Install 4 new AA alkaline batteries into the moulded battery compartment of transmitter. Noting correct location polarity.
4.
Close the battery compartment cover.
Important note:
It is very important that the throttle lever (left) is in the lowest position when you switch on the transmitter.
Whenever you reconnect the transmitter and receiver, this lever must be in the lowest position. If the remote-control light
flashes, pull the lever down.
5.
Turn on the switch. The green indicator light should light up. If this is not the case, check the previous steps,
