24
User Guide
EN
Dansensor
®
LeakPointer
H
2
O
Adjustments
Lid adjustment
If the lid does not seal properly and evenly against the tub sealing, this can be adjusted:
NOTE! This requires that the sealing is correctly mounted on the tub - see
"Replacement of parts" on page 26
1. Loosen the 4 screws
(2 on each side) connecting the lid
to the console
.
2. Close the lid
and while slightly pressing it downwards, start the vacuum ejector and
adjust vacuum to approx. 100 mbar.
3. When you feel the lid being sucked close to the tub, verify that the lid seals evenly against
the tub sealing, then tighten the 4 screws
again.
4. Release the vacuum then start test again to check that lid seals properly now.
Summary of Contents for mocon Dansensor LeakPointer H2O
