Dansensor
®
LeakPointer
H
2
O
EN
User Guide
25
Adjusting the tub positioning sleeves
NOTE! We recommend that two persons perform this operation, as it requires for
the unit to be tilted while screws are tightened underneath.
If the tank is slightly skewed or if it needs to be turned to change the location of the drain
outlet, it may be necessary to slightly adjust the tub positioning sleeves:
1. Drain the tub
and lift it off.
2. Tilt the unit to be able to loosen the 4 screws
(underneath) that secure the sleeves
to the base
.
NOTE! The screws
should only be loosened so much that it still requires a
little force to move the sleeves
.
3. Mount the tub
in the sleeves
again and then close the lid
to check the alignment
of the lid and the sealing
. If necessary wiggle the tub
to adjust the positions of the
sleeves
.
4. When finished, while holding the lid closed to keep the tub in place, tilt the device
backwards to be able to tighten the 4 screws
.
Summary of Contents for mocon Dansensor LeakPointer H2O
