Ametek Chandler Engineering 4207D, Operating Manual

Page: 37 / 47

CONTROLLER CONFIGURATION 7
Display Configuration
The following table contains the default configuration for the load cell display.
FULL
MENUS Comment CONFIG
MENUS Comment
HOME INST
dSP.F PV Displays the present value
on the front display unit None No Engineering units
dSP.b PV.Hi Displays the peak value on
the back display dEc.P nnnn. 5-digit display
Cid 0.0 ID number Ac.bu Enab Front panel Ack/Reset button
AL
IP
1___ 0.0 Not used inP.t mV Input type
2___ 0.0 Not used CJC N/A Not used
3___ 0.0 Not used imP Auto Input impedance
4___ 0.0 Not used tYPE Ld.C Load cell calibration
0.0 Not used bAnd 0.01 Settling band
SP inP.L 0.0 Low input value
SP L 0.0 Set Point Low Limit inP.H 24.4 Varies with load cell calibration. Must be equal to
same value in controller
SP H 50000 Set Point High Limit VAL.L 0.0 Low calibration value corresponding to low input
value
VAL.H 50000 High calibration value corresponding to low input
value
IP
FiL.t STEP Step filter type AL
Int.t N/A Not used AL 1 OFF Not used
StP.b 1.0 Step filter band Ltch
OFS.1 Varies value with no load bLoc
OFS.2 N/A Not used AL 2 OFF Not used
Lo.IP N/A Not used Ltch
Hi.IP N/A Not used bLoc
F.1 N/A Not used AL 3 OFF Not used
F.2 N/A Not used Ltch
PU.iP iP.1 Selects input 1 bLoc
EmiS N/A Not used AL 4 OFF Not used
Emi.2 N/A Not used Ltch
PU.SL iP.1 Shows the selected input bLoc
CAL 1 LA
tArE OFF Not used id LoG.I Not used
CAL.P 3 Calibration password Func None
cmS LB
Addr 2 Modbus I/O Address id LoG.I Not used
Func None
INFO
LoG.L Read Only Minimum process value AA
LoG.H Read Only Maximum process value id rEL.Y Not used
LoG.A Read Only Average process value Func None
LoG.t Read Only Time process value above
threshold value
SEnS
LoG.u 0.0 Process value threshold AL 1
rES.L No Changing to "Yes" resets
the peak value in Modbus
Register 133 AL 2
AL 3
Al 4
Sbr
SPAn
rmt.F
iP1.F