MX15 Series
81
4.2.9 CONFIGURATION Menu
The configuration menu may be used to configure various aspects of the instrument such as the
serial port (including USB and LAN), IEEE-488/GPIB address and the power-on settings of the
supply.
ENTRY
DESCRIPTION
ADDRESS
0 - 31
Sets the selected IEEE / GPIB bus address for the optional
IEEE/GPIB interface.
Factory default is address 1. The shuttle knob or the keypad
can be used to set a value from 0 through 31. Do not use
address 0 as this address is typically reserved for the GPIB
controller.
BAUD RATE
9600
19200
38400
57600
115200
230400
460800
Sets the baud rate for the RS232 communications port.
Factory default is 38400 baud. Available settings are 9600
through 115200 baud.
The same setting is used for USB and LAN modes. For use with
either USB or LAN, the baud rate in this screen must be set to
460800.
Note: The shuttle knob can be used to scroll through these
selections.
PON STATE
REG0
RST
Determined power on state. This setting selects either non-
volatile REG0 to be recalled automatically at power-on or
factory default (RST). Factory default is RST, which recalls the
factory settings. See below.
Factory default settings are:
Output relay
Open
Voltage Range
Low
Mode
AC
Voltage 0 Vrms
Frequency 60 Hz
Note that to use REG0 for power-on default, the contents of
the register must be programmed first. See section 4.2.8. If an
empty register is selected, the power source will revert back to
RST (factory setting).
LANetwork
LAN
If the –LAN option is installed; pressing Enter while the cursor
is on the LANetwork entry provides access to the LAN interface
setting screens listed below.
IP Address
Displays the IP address setting. This value can be changed by
pressing the SET key and entering a new value from the
keypad. Use the numeric data pad to enter each field. To move
between the four fields, use the decimal point key on the
keypad.
To set a fixed IP address, press SET and enter the desired IP
Summary of Contents for California Instruments MX15 Series
