Ametek Land Millwatch, User Manual

Page: 43 / 44

Page 37
Millwatch/Silowatch
Single Stream
User Guide
Unit
Parameter Actual
Setting
Units Description
FUEL 2 k2 Calculation constant (k2) for Fuel
Type 2.
FUEL 2 CO MAX Stoichometric value of Fuel Type 2.
FT MIN DegC Minimum value for the flue
temperature CLIP.
FT MAX DegC Maximum value for the flue
temperature CLIP.
FT ZERO mA Minimum current for the flue
temperature CLIP.
AMB MIN DegC Minimum value for ambient
temperature CLIP.
AMB MAX DegC Maximum value for the ambient
temperature CLIP.
AMB ZERO mA Minimum current for ambient
temperature CLIP.
UNITS Units used for gas concentrations.
O2 NORM O2 normalisation applied.
O2 REF O2 reference value for
normalisation.
WET ANALYSIS Wet analysis applied to gas
concentrations.
WATER Water vapour concentrations for
wet analysis.
CO2 COMP CO2 factor for O2 compensation.
SHOW NEGATIVE Allows display and output of
negative values.
ENTRY CODE Allows new code to be entered.
BLOW BACK Manually purge the probe.
SET CLOCK N/A Allows system clock to be set.
CLEAR FAULTS N/A Clears fault flags (Ongoing faults
remain flagged).
RESTORE CONST. N/A Restores the previous calibration
constant settings.
OUTPUT CO2 Allows CO2 to be output on current
loop O/P 4.
The following information is found under "System Data".
CO Span Constants can be changed in the Setup.
CO Span Constants
RED CELL BLUE CELL
O2 Span Constants
O2 Span Constants can only be changed with a calibration.