Ametek Drexelbrook ThePoint Series, Installation And Operating Instructions Manual, Page: 66 / 70

ThePoint Series
A2
CE Installation Supplement
440-0018-731
Sht. 1
of 2
APP'D BY
SGA
ISSUE EDO NO. APP'D
DATE
3 2-16-102 THP 2-1-16
4 11-17-100 SGA 11-3-17
EMC Installation Supplement
A.
Purpose:
To provide additional information that is required to be in compliance with
the CE mark of conformity and 2014/30/EU Directive.
B. Definitions: 1. I/O Sensor/Measurement/Control Port -- Any port which provides
level measurement, control, and/or DC power.
2. I/O AC Power -- Any port which provides AC main power to the
instrument.
3. Housing -- Any enclosure where the sensor and transmitter can be
located.
4. Non-metallic applications -- any application where the sensor is
not surrounded by a metallic surface.
C.
Installation Specifics:
1. I/O Sensor/Measurement/Control Ports

Wiring must be twisted pair and run in conduit or an equivalent
shielded environment (i.e. shielded braid, cable, etc.).
 The shield terminations must be grounded at the source and
destination ports.

Wiring must be run separate from AC main power and/or any
signal exceeding 75 volts DC or 50 volts AC.
2.
I/O AC Power Port

Wiring must be run either in conduit or an equivalent shielded
environment (i.e. shielded braid, cable, etc.).
 The shield terminations must be grounded at the source and
destination ports.