33
STAIRLIFT TEST RUN PT. 1
Important:
If there are any issues with the stairlift, the system may display System Status Codes.
Refer to the System Status Codes section for more details of what these codes mean.
To test run the stairlift (unladen):
Make sure the area covered by the movement of the stairlift is free of obstructions.
Fold down the footrest and swivel the seat into correct travel position. Leave the armrests in the
upright position. Do not allow any weight to rest on the carriage as yet.
Run the unladen stairlift to the very bottom of the track. While the stairlift is travelling check:
1. Footrest, folded down, to riser clearance.
2. Armrest and seat back clearance, especially on staircases with low bulkheads.
3. Seat back clearance to wall or railing posts.
4. Arm rest clearance to wall when swivelled.
At the bottom check that the stairlift is charging correctly and the footrest is at the correct
height to allow the user to easily access the stairlift. When the lift is properly charging, the word
“Platinum” will be displayed on the LED screen.
Run the stairlift to the top of the track while checking all above points.
At the top check that the stairlift is charging correctly and the footrest is at the correct height
to allow the user to easily access the stairlift. Also check the swivel radius to ensure that the
downside armrest or seat back does not come into contact with the opposite side of the staircase.
TEST RUNNING STAIRLIFT - EMPTY
I f t h e fo o t re s t co n t a c t s a ny s te p r i s e. . .
Fold arms, seat and footrest into the UP position. Remove
foot screws and move entire rail forward by moving the feet
positions closer to the nose of the step.
I f t h e c h a i r co n t a c t s wa l l w h e n s w i ve l e d. . .
Move the entire rail farther away from the wall.
B e c a re f u l t h at t h e
c h a i r d o e s n’t t i p
ove r w h i l e m a k i n g
a d j u s t m e n t s.
TIGHTEN LEGS
Once you have determined that you have the proper clearances for your stairlift, tighten all
Leg
screws.
At this point, spread small dabs of the gear lubricant approximately 6-8” along the gear
teeth.
Press manual swivel levers and turn chair, make sure it locks securely at either end of travel and that
the swivel interlock switch operates correctly. Key is attached to the arm with a tie wrap, detach and
insert into keyswitch under armrest.
