11
An Assembled
Leg
and how it fits into the rail is shown below. These will be used in the next step.
ASSEMBLED LEGS
LEG ASSEMBLED
TIGHTEN BOLTS
BEFORE INSTALLATION
LEG ON RAIL
PRO TIP:
Place a piece of cardboard onto the floor to protect it while positioning the rail onto the stair case.
This piece of cardboard can also act as a spacer for the rail clearance at the bottom (1/2” to 3/4”).
Make sure the legs are
straight and then tighten,
using two 13mm wrenches.
This ensures that they do
not move during installa-
tion process.
Place assembled
Legs
at the upper
and lower end of the
B o t to m R a i l
S e c t i o n
. The
Legs
will rotate into
place fully assembled.
The lower end
Leg
should be located
so that it sits on the step above the
bottom landing.
The upper end
Leg
should be locat-
ed on the step just below the end of
the rail.
Adjust the Legs to give the proper
1/2” to 3/4” clearance between the
railing and the floor. Lightly finger
tighten Leg bolts to hold in place.
NOTE: When Installing the rail on the staircase the teeth of the gear rail will face the wall.
FIT LEGS TO BOTTOM RAIL SECTION
1/2”-3/4”
Clearance
ADD LEGS TO BOTTOM RAIL SECTION
AND ADJUST BOTTOM CLEARANCE
top jointing plate
charging cable
