12
Place assembled Legs onto the
To p
R a i l S e c t i o n
. The
Legs
will rotate
into place fully assembled.
The lower end
Leg
should be located
so that it sits on the step above
where the two rails will join.
The upper end
Leg
should be locat-
ed so that it will rest on the step just
below the top landing. Lightly finger
tighten Leg bolts to hold in place.
Adjust top and bottom Legs so that
the
To p R a i l S e c t i o n
aligns with
the
B o t to m R a i l S e c t i o n
on the
stair case.
NOTE: If there is a 3rd rail section, repeat previous “Fit Legs to Top Rail Section” step.
NOTE: Additional
Legs
can be installed in the middle of the longest rail section.
NOTE: Do Not Install upper section of gear rack at this time.
FIT LEGS TO TOP RAIL SECTION
ADD LEGS TO TOP RAIL SECTION
AND MOVE INTO PLACE FOR NEXT STEP
SLIDE BOTTOM JOINTING PLATE
INTO BOTTOM RAIL SECTION
SLIDE TOP RAIL SECTION ONTO
BOTTOM RAIL SECTION &
TOP JOINTING PLATE
SLIDE BOTTOM JOINTING PLATE UP
TO STRADDLE BOTH RAILS & TIGHTEN.
Slide the
Bottom Jointing Plate
into the
B o t to m R a i l S e c t i o n
as shown below. Move the
To p
R a i l S e c t i o n
downward so that it slides onto the
Top Jointing Plate
and
B o t to m R a i l S e c t i o n
.
Slide the
Bottom Jointing Plate
up so that it straddles both rails and tighten screws, securing the two
rails together.
