Americana Outdoors, Inc.
3
Cherokee Installation Guide
CORRECT
TOO LOOSE
TOO TIGHT
Installation Notes and Tips
(continued)
•
Avoid over
-
driving, under
-
driving, or driving at an angle to properly install fasteners. Over
-
driven
fasteners can depress the material and allow water to collect around the fastener, which will corrode
the surface finish. Under
-
driven fasteners can cause leaks and may back out over time.
•
The center
-
to
-
center spacing of the roof panel locks must be maintained as the panels are installed.
If this is not done, problems may not show up until towards the end of the installation when parts may
appear to be cut too short or too long. If this happens, check each roof panel spacing and re
-
set if
necessary.
•
We strongly recommend using a high grade sealant, such as our 100% silicone caulk and sealant.
Caulking should be applied uniformly and without skips. A poor caulking job can cause leaks.
Note:
These are basic installation guidelines for our standard load units and may not be suitable to your
specific installation. It is important to follow all local and national building codes when installing any
exterior improvement product. If you have questions regarding the proper installation of any Americana
product, please call us toll free at 1
-
888
-
442
-
2928 and ask for assistance. Hours are 8:00am
-
5:00pm
Central Standard Time, Monday
-
Friday.
Refer to the provided manufacturer
’
s drawing for details and special notes.
Americana will not be responsible for delays or lost installation time due to failure to follow all instructions.
Care and Maintenance
Every 12 months your shade structure should be inspected and maintained by:
•
Tightening loose nuts and bolts at all connections.
•
Repairing damage to the finish to prevent corrosion.
•
Replacing lost or damaged fasteners, brackets, and other parts.
•
Replacing brittle or cracked sealer to prevent leaks.
•
Removing obstructions and miscellaneous build
-
up from gutters, eaves, and downspouts.
