23
© American Time
Wireless Remote Transmitter Installation Manual
Glossary
Appendix
Troubleshooting
Clock
Installation
Transmitter and
System Setup
Intr
oduction
Wireless Digital Clock
Installation
CAUTION: RISK OF ELECTRICAL SHOCK
- Disconnect and lock out power to the
electrical box before installing or servicing the clock.
u
Make electrical connections for the Molex cable (not wired to the clock) to
a non-switched electrical circuit wiring using UL approved wire nuts.
(black to hot, white to neutral, green to ground) Route field wiring away
from sharp projections and corners.
v
Connect mounting screws (not included) to the electrical box so that they
line up with the mounting holes on the back cover of the clock. Two screws
(single gang) or four screws (double gang).
These screws should not be screwed in completely, leaving room for the
clocks back cover to mount on the screws properly.
w
Join the two Molex connectors together, placing excess wiring and Molex
connectors into the gang box.
x
Mount the clocks back cover on the mounting screws added to the gang
box in Step 1.
y
Apply power to the circuit and confirm correct operation.
American Series Digital Single Display Surface Mounting
American Series Digital Single Display Flush Mounting
American Series Digital Double Face Display Mounting
CAUTION: RISK OF ELECTRICAL SHOCK
- Disconnect and lock out power to the
electrical box before installing or servicing the clock.
u
Remove the four sheet metal screws that hold the cover assembly and
enclosure base together. Be sure to keep the sheet metal screws for
reassembly.
v
Mount the enclosure base into the wall. Opening is 12.5" x 7.4" x 3.629".
w
Run interconnecting field wires through the enclosure base.
x
Make electrical connections (hot, neutral, ground wires) to non-switched
electrical circuit wiring using UL approved wire nuts. Route field wiring
away from sharp projections, corners and internal components.
y
Join both Molex connectors together, placing excess wiring and Molex
connectors into the gang box.
z
Re-attach the cover assembly to the enclosure base using the sheet metal
screws removed in Step 1.
Apply power to the circuit and confirm correct operation.
CAUTION: RISK OF ELECTRICAL SHOCK
- Disconnect and lock out power to the
electrical box before installing or servicing the clock.
u
For wall mount, assemble double dial clock enclosure as shown in Figure 1.
For ceiling mount, use the same assembly procedure, except use the two
knockouts that are located on the top of the wraparound (see Figure 2).
v
Depending on the orientation of the 4" square backbox, use two #8-32 x
3
/
4
"
screws and two #8-32 nuts for the two dummy holes in the mounting plate.
w
Run power and reset wires through conduit.
x
Using two #8-32 x
3
/
4
" screws, mount double dial clock enclosure assembly to
4" square backbox (see Figure 2).
y
Loosen the four screws in the digital clock approximately
3
/
32
" (see Figure 2)
z
Make power and reset wire connections to the digital clock.
Slide the digital clock into the wraparound making sure the screws and slots
line up (see Figure 2), then tighten the four screws securely.
Repeat steps 5 through 7 for the second clock
n
Note:
Time format (12 or 24 hour) for American Series Wireless Digital Clocks is set in Remote Transmitter Connect. The format can be
viewed or changed in Remote Transmitter Connect under the Configuration Tab, Time Display Format 12 Hour 24 Hour.
Slots
Screws
4 square
backbox
(not supplied)
Wraparound
Digital clock
Digital clock
Knockouts for ceiling mount
WALL
Wraparound
Plate
Bushing
Locknut
Conduit
Figure 1
Figure 2
