-3 EN-
Do not attach the product to any water source
other than potable water.
It may cause electric shock, fire and skin
inflammation due corrosion of electronic parts
inside the seat unit.
Do not disassemble or modify the product.
It may cause electric shock or fire.
Do not use loose outlet.
It may cause electric shock or fire.
CAUTION
Install a high-sensitivity, high-speed ground
fault circuit interrupter (with a rated current
value of 15 mA or below) on the primary side
of the power supply.
There is a danger of electric shock.
The SpaLet
®
bowl is made of ceramics, and
ceramics are fragile. Note the following when
handling the SpaLet bowl:
–– Prior to installation, make sure that the
SpaLet bowl is in a good condition and
not damaged.
–– After installation, check the SpaLet bowl
for any damages.
Failure to do so may cause injury, water
leakage and/or flooding.
Wash out foreign materials or rust inside the
pipes before connecting the product.
Failure to do so could damage the internal
parts of the product, which may cause water
leakage and/or flooding.
Note the following when using the strainer:
–– Close the water shutoff valve when
removing the strainer.
–– When installing the strainer, tighten it
fully so there is no gap.
–– Check that the O-ring is free from
foreign materials when attaching it.
If foreign materials are attached to the O-ring,
it may cause flooding due to water leakage.
Adjust the water shutoff valve and check for
water leakage after the installation.
It may cause water leakage and/or flooding.
If the water is expected to be frozen,
drain the water out from the product.
Failure to do so may cause fire, water
leakage, and/or flooding due to damage
from freezing.
Drain the air from the pipes after any
building construction or renovation, or
when water supply is restored after an
interruption.
If the water supply contains air, it may
cause damage or malfunction to the
product or pipes. There is a danger of
injury or damage to the building or
furniture due to flooding.
