background image

7302427-100 (3/19)

13

- 4 -

 

• Make sure water supply is 

  off. Remove valve TOP by 

  lifting arm and rotating top 

  and arm 1/8 turn 

  counterclockwise, pressing 

  down slightly on cap.

IMPORTANT: Always clear 

sand and rust from system.

• While holding a container 

over the uncapped VALVE 

to prevent splashing, turn 

water supply on and off a 

few times. Leave water 

supply off.

• Replace TOP by engaging 

  lugs and rotating 1/8 turn   

  clockwise. MAKE CERTAIN 

  TIP IS TURNED TO THE 

  LOCKED POSITION. VALVE 

  MAY NOT TURN ON IF TOP 

  IS NOT FULLY TURNED TO 

  THE LOCKED POSITION.

For troubleshooting information please contact:

TROUBLESHOOTING

IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK 

SLOWLY, repeat Step 13.
IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF 

NON-USE, it is a signal you are wasting water because:
• The end of the refill tube is inserted into overflow pipe, below

   water level in tank. Attach refill tube to overflow pipe using "S"

   clip provided.
• The flush valve is leaking because it's worn, dirty or

   misaligned with tank ball or flapper (replace with a new flapper).
IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL OF 

TANK WATER IS SLOW after valve has been in use for some 

time, Fluidmaster Model 242 Replacement Seal may be needed.
Go to our website at www.fluidmaster.com for more solutions 

to toilet problems.

©  2001 Fluidmaster, Inc.

®  Registered trademark of Fluidmaster, Inc.

Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster shall 

not be responsible or liable for any damages caused by products used with Fluidmaster valves that were 

not manufactured by Fluidmaster, Inc.

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675

(949) 728-2000  (800) 631-2011

www.fluidmaster.com

    Does not flush

 

Poor or sluggish flush

         
Toilet leaks

Toilet does not shut off

a.  Water supply valve closed.
b.  Supply line blocked.

c.  Flush valve chain too loose or disconnected.
d.  Sand or debris lodged in water control.

a. Bowl water level too low.

b.  Supply valve partly closed.
c.  Partially clogged trapway and/or drain pipe and/or vent.
d.  Supply pressure too low.

a.  Poor supply line connection.
b.  Poor bowl to tank/floor connection.

a.  Flush valve chain too tight, holding flush valve open.
b.  Flush valve seat and/or flapper worn or deformed.
c.  Sand or debris lodged in water control.

a.  Open valve and allow water to fill tank.
b.  Shut off water supply, disconnect supply line and inspect all gaskets and
     washers. Reassemble. Also, see Fluidmaster maintenance. (see Step 13)
c.  Readjust chain length as required.
d.  Shut off water supply. Remove cap and clean as per Step 13.

a.  Check that refill tube is connected to water control and inserted into tank
     overflow without being kinked or damaged.   
b.  Open supply valve fully. Be sure that proper supply tube size is used.
c.  Remove obstruction. Consult a plumber if necessary.
d.  Normal supply pressure must be at least 20 psi.

a.  Review Step 9 of installation procedure.
b.  Review Step 4 through 7 of installation procedure.

a.  Readjust chain length as needed. Review Step 10.
b.  Shut off water supply. Replace flush valve.
c.  Shut off water supply. Remove cap and clean per Step 13.

                         TROUBLESHOOTING GUIDE

 PROBLEM

                          POSSIBLE CAUSE

                                       CORRECTIVE ACTION

LIFT ARM

FIRST

In the United States:

American Standard Brands

1 Centennial Ave

Piscataway, New Jersey 08854

Attention: Director of  Consumer Affairs

For residents of the United States, warranty 

information may also be obtained by calling 

the following toll free number: (800) 442-1902

www.americanstandard.com

In Canada:

LIXIL Canada ULC

5900 Avebury Rd.  

Mississauga, Ontario 

Canada L5R 3M3

Toll Free:  (800) 387-0369

www.americanstandard.ca

In Mexico:

American Standard B&K Mexico

S. de R.L. de C.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico

Toll Free: 01-800-839-1200

www.americanstandard.com.mx

Summary of Contents for 3851A













Reviews: