15
THROTTLE CONTROL (STOCK CARBURETOR)
•
Measure the conduit to the desired length and cut to
fit. The conduit should be about 6” shorter than the
cable. Don’t cut too short, leave a little extra room.
You can always cut a little more, but you cannot add
any length.
•
Make sure you use a sharp wire cutter when cutting
the cable. A clean, quick cut will prevent the cable
from fraying. You are going to thread the cable
through the barrel connector at the carburetor. If
you fray the cable, cut off a few of the frayed strands
•
Install the throttle cable into the twist grip control so
that the barrel end slips into the notch.
•
Install the Throttle Control onto the handlebar. (on
the right when sitting on the bike). Using a Philips
screw driver, gently tighten each screw a little at a
time.
Don’t over tighten the screws. Too tight, and
your control will bind when you twist it. Too loose,
and it will move when operated
.