16
•
Route the Throttle Cable and Housing down the Fork
and right of the Frame toward the carburetor, using
conduit clips to secure the Cable and Housing to the
Fork and frame as you go. Go past the carburetor,
then loop the cable back to the carb.
•
Remove the air cleaner assembly from the
carburetor by removing the nut on top.
•
Loosen the nut that secures the manual throttle lever
so that the lever can move freely.
•
You will see an L bracket. Fasten the conduit to this
bracket to hold it place. Loop the cable to come in
from the back.
•
You will see a barrel connector at the throttle lever.
Loosen the screw, thread the cable into the barrel
connector, then tighten the screw. Be sure the cable
is pulled through the barrel connector until snug.
•
You will likely have to re-adjust this once you start
and test the engine.
•
Re-Install the air cleaner assembly.
•
Note: The throttle mechanism will appear to not be
operating when the engine is not running. The
engine must be running for the throttle to operate
•
See more full information for throttle linkage here
•
https://gokartsusa.com/pdf/Honda-GX-Throttle-
Linkage.pdf
•
Cable Installation on Stock Carburetor (Summary)
Remove the Air-Cleaner assembly so you can see the Throttle
Control Mechanism. Loosen the nut that secures the manual
throttle lever so that the lever can move freely. Locate the
conduit bracket on the engine. and fasten the end of the
conduit with the bracket. Thread the cable into the Wire Stop
connector on the engine. Tighten the screw on the Wire Stop