Page 30
8.
Insert the two y-shaped wire terminal connectors, and then fasten the screw to secure the
terminal connectors.
9.
Mount controller to wall by drilling 2) 6mm holes 92mm apart at installation location, and
insert the Expansion Anchors supplied.
10.
Separate the panel cover from the remote base, secure remote base to wall with (provided)
screws.
11.
Replace front cover.
12.
Attach remote wires to the UNIT as follows …………..
1.Remove the front cover of unit
2.Disconnect the remote control cable, then the cable is separated into two parts,
cable
①
and cable
②
;
3.Thread the cable
②
through the access hole at bottom cover of unit and secure the
socket of cable
②
into the hole
②
①
②
②
Summary of Contents for AHG-T42-LP
Page 38: ...Page 38...
