Connector Wiring and Assembly:
1. Slide parts (1), (2), (3), (4), and (5) (see Figure 9) over the
Pan/Tilt cable outer sheath.
2. Remove outer sheath 0.75" from cable end.
3. Remove each conductor insulation 0.25" from its end.
4. Solder the Pan/Tilt cable conductors to socket contacts (6).
a. The Pan/Tilt AC Common wire to P/T common pin 1.
b. The Pan Right wire to Right pin 2.
c. The Pan Left wire to Left pin 3.
d. The Tilt Up wire to Up pin 4.
e. The Tilt Down wire to Down pin 5.
f. The Preset/Servo + REF wire to Error (+) pins 7 and 10
(connect to both pins).
g. The Preset/Servo - REF wire to Error (-) pins 9 and 12
(connect to both pins).
h. The Preset Pan Wiper wire to Pan pot wiper pin 8.
i. The Preset Tilt Wiper wire to Tilt pot wiper pin 11.
j. For the AutoPan model, the AutoPan/AUX wire to
AutoPan pin 6.
or
For the Heater model, the Heater/AUX wire to Heater
pin 6.
Note: Refer to the appropriate driver or controller
manual to identify the applicable AutoPan or
Heater (AUX) wire for this connection.
5. Slide female insert (6) into coupling ring (7). Press insert
until the arms of the insert are locked into the coupling ring
and the locking tabs are engaged in the coupling ring slots.
6. Press O-ring (8) over fully assembled female housing insert
part (6).
7. Slide and thread the jacket (5) onto coupling ring (7).
8. Slide and thread the angle housing (4) onto jacket (5).
9. Slide the rubber gasket (3), pinch ring (2), and locking
screw (1) into the angle housing (4).
10. Screw part (1) into part (4) to ensure a good seal between
the cable and the rubber gasket (3).
11. Connect the cable shield to the SHIELD terminal of the
Receiver/Driver.
Note: Attach the cable to the AD1240 using the strain relief
assembly on the bottom of the main body (page 10).
9
AD1240
CONNECTIONS
1
2
3
4
5
7
1 Locking Screw
2 Pinch Ring
3 Rubber Gasket
4 Angle Housing
5 Jacket
6 Female Insert
7 Coupling Ring
8 O - Ring
Cable conductors
6
8
Locking Tabs
Figure 9 - 13-Pin Connector Assembly
