12
2. If more headroom is needed when moving the dryer into position, the top console (module) may be removed.
a. To Remove Top Console (module)...
1) Disconnect the ground wire (A in the
illustration below
) located at the rear upper left corner of
the dryer.
2) Remove the six (6) sets of nuts and washers (B in the
illustration below
) holding the console
(module) to the base.
3) Disconnect the white plug connector (C in the
illustration below
) located on the top of the rear
electric service/relay box (provides power to the heat circuit).
4) Disconnect air connection from the 3-way micro valve.
5) Lift the console (module) off of the dryer base.
IMPORTANT:
The dryer
must be
transported and handled in an upright position at
ALL
times.
Summary of Contents for Phase 7 / OPL ensor Activated Fire Extinguishing System D120
Page 23: ...19 ...
