ADJ Products, LLC - www.adj.com - WiFLY Bar QA5 User Manual Page 13
ADJ Products, LLC - www.adj.com - WiFLY Bar QA5 User Manual Page 14
1. Plug the fixture in and press the MODE button until “AUTO” is dis-
played.
2. Press the SET UP button until “rFXX” is displayed. “XX” repre-
sents either “on” or “oF”.
3. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
WiFLY Address:
This function is used to set the WiFly address. This address must
match the address that is set to WiFly TransCeiver or WiFly controller.
1. Plug the fixture in and press the MODE button until “rCXX” is dis-
played. “XX” represents a number between 00-15.
2. Press the UP or DOWN buttons to either activate the remote func-
tion (On) or deactivate it (Off).
Dimmer Curve Setting:
1. Plug the fixture in and press the MODE button until “d.XXX” is dis-
played. Now press the SET UP button until “dr-X” is displayed,
“X” representing a number between 0-4.
2. There are 5 dimmer curve settings to choose from. Please see the
Dimmer Curve Diagram Chart on page 23 to see the settings and
their respective beginning and ending fade times.
WiFLY Bar QA5 Operating Instructions
WiFLY Bar QA5 Operating Instructions
2. To run your fixture in DMX mode press the MODE button until
“d.XXX” is displayed. “XXX” represents the current displayed ad-
dress. Use the UP or DOWN buttons to select your desired DMX
address. then press the SET UP button to select your DMX
Channel mode.
3. When you press SET UP “ChXX” should be displayed. “XX” repre-
sent the current DMX Channel Mode.
4. Use the UP or DOWN buttons to scroll through the DMX Channel
modes. The Channel modes are listed below:
• To run the 4 Channel Mode, press the MODE button until “Ch04”
is displayed.
• To run the 6 Channel Mode, press the MODE button until “Ch06”
is displayed.
• To run the 7 Channel Mode, press the MODE button until “Ch07”
is displayed.
• To run the 8 Channel Mode, press the MODE button until “Ch08”
is displayed.
• To run the 9 Channel Mode, press the MODE button until “Ch09”
is displayed.
• To run the 22 Channel Mode, press the MODE button until
“Ch22” is displayed.
5. Please see pages 18-25 for DMX values and traits.
6. After you have chosen your desired DMX Channel mode plug in
the fixture via the XLR connections to any standard DMX control-
ler.
Battery Life:
This menu is used to check/display the battery life.
1. Plug the fixture in and press the MODE button until “bXXX” is dis-
played. “XXX” represents a number between 0-100. The number
that is displayed is the remaining battery life. If “b---” is displayed,
it means either the battery is dead or your running the unit on AC
power.
ADJ RFC:
This function is used to activate and deactivate the ADJ RFC (Remote
Control). When this function is activated you can control the fixture
using the ADJ RFC. Please see the next page for ADJ RFC controls
and functions.
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 10 fixtures maximum. After 10 fixtures you will need
to use a new power outlet. They must be the same fixtures. DO
NOT mix fixtures.
NOTE: Fixtures cannot be power cord daisy chained and run by
battery power.
WiFLY Bar QA5 Power Cord Daisy Chain
