ADJ Products, LLC - www.adj.com - Illusion Dotz 4.4 Instruction Manual Page 27
ADJ Products, LLC - www.adj.com - Illusion Dotz 4.4 Instruction Manual Page 26
Illusion Dotz 4.4
System Menu
4. “XXXX”
will now be displayed.
“XXXX”
represents the current run-
ning time.
5. Press ENTER or press MODE to exit.
TOTAL RUNNING TIME -
This will allow you to check the units total
running time.
1. Press the MODE button to access the main menu. Press the UP
or DOWN buttons so that
“Information” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until
“Time Information” is dis
-
played, press ENTER.
3. Press UP or DOWN buttons, until
“Total Time” is displayed, and
press ENTER.
4. “XXXX”
will now be displayed.
“XXXX”
represents the total run-
ning time.
5. Press ENTER or press MODE to exit.
LAST CLEAR -
This will allow you to check when the last running
time was cleared.
1. Press the MODE button to access the main menu. Press the UP
or DOWN buttons so that
“Information” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until
“Time Information” is dis
-
played, press ENTER.
3. Press UP or DOWN buttons, until
“Last Clear” is displayed, and
press ENTER.
4. “XXXX”
will now be displayed.
“XXXX”
represents the last running
time.
5. Press ENTER or press MODE to exit.
RUN PASSWORD -
This will display the timer password.
1. Press the MODE button to access the main menu. Press the UP
or DOWN buttons so that
“Information” is highlighted, then press
ENTER.
Illusion Dotz 4.4
System Menu
2. Press the UP or DOWN buttons until
“Time Information” is dis
-
played, press ENTER.
3. Press UP or DOWN buttons, until
“Timer Pin” is displayed, and
press ENTER.
4. The
“Timer Pin”
is 050.
5. Press ENTER or press MODE to exit.
CLEAR LAST -
This will allow you to clear the last run time of the
unit. You need to put in the
Timer PIN
before doing this. Please see
the section before this.
1. Press the MODE button to access the main menu. Press the UP
or DOWN buttons so that
“Information” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until
“Time Information” is dis
-
played, press ENTER.
3. Press UP or DOWN buttons, until
“Clear Last” is displayed, and
press ENTER.
4. Either “Off” or “On”
will be displayed, use the UP and DOWN but-
tons to toggle between.
5. Press ENTER to confirm your selection or press MODE to exit.
TEMPERATURE INFO -
This will allow you to check the moving
head temperature.
1. Press the MODE button to access the main menu. Press the UP
or DOWN buttons so that
“Information” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until
“Temp. Info” is displayed,
press ENTER.
3.
“Head Tem.”
will now be displayed, press ENTER.
4. “XXX”
will now be displayed.
“XXX”
represents the current tem-
perature of the moving head.
5. Press ENTER or press MODE to exit.
