![background image](http://html1.mh-extra.com/html/american-dj/fog-fury-3000-wifly/fog-fury-3000-wifly_user-instructions_2922971004.webp)
ADJ Products, LLC - www.adj.com - Fog Fury 3000 WiFly Instruction Manual Page 6
ADJ Products, LLC - www.adj.com - Fog Fury 3000 WiFly Instruction Manual Page 7
Fog Fury 3000 WiFly
Description
The new Fog Fury 3000 WiFly fog machine features a fog juice level sen-
sor. When the fog juice level is low, a LED below the reservoir will flash.
When the fog juice level reaches a lower level, a bult-in sensor inside the
reservoir will automatically shut off the pump. This will greatly expand
the life of the pump. The new Fog Fury 3000 WiFly fog machine included
a revolutionary new heating element that has been specially designed
to prevent excessive particle build up that can cause premature fogger
failure. The fog machine also includes a remote control, that may be
removed for periods on non-use.
Fog Fury 3000 WiFly
Set-Up
1. Open the shipping carton and carefully remove the unit from the
shipping carton.
2. Be sure to remove all the packing material especially around the
nozzle.
3. Set the fog machine on a flat dry surface. Locate the included
bracket from the package and install it using the supplied hard-
ware to the side casing. Note: The bracket is an optional accesso-
ry and may not be used if desired, however if you intend to sus-
pend the unit from truss the bracket must be used.
4. Fill the fog fluid reservoir with ADJ
brand fog juice. Place the feed-
er tube with the filter deep inside the reservoir and tighten the cap.
5. Firmly attach the remote control unit to the rear remote control
socket on the unit.
6. Plug the unit in to a matching power supply. At this time the fluid
reservoir will glow red, this indicates that the unit is heating up.
Wait about eight minutes for the fogger to reach normal operating
temperature. When it has reached the temperature, the reservoir
will glow green.
7. Either press the remote button to emit fog or use the manual but-
ton on the rear of the unit to emit fog. See the next pages for timer
control and DMX control.
8. Follow the operating instructions on the next page for proper
operation.
NOTE: If the LED under the reservoir begins to flash, this indicates that
fog juice fluid is low.
Fog Fury 3000 WiFly
Layout
A
A .
Bracket
B .
Handle
C .
Fog Fluid Tank
D .
Power Switch
E .
Timer ON/OFF
F .
Fog Switch
G .
LED display
H .
Manu
I .
Up
J .
Down
K .
DMX 3 pin XLR Output
C
F
G
I
K
R
Q
P
L
M
S
U
O
J
N
E
H
D
T
B
L .
DMX 3 pin XLR Input
M .
Control Socket Connection
N .
Antenna
O .
Signal Strength Meter
P .
Indicator LED –Radio (Green LED)
Q .
Indicator LED – DMX (Yellow LED)
R .
Indicator LED – Power (Red LED)
S .
Wifi Channel Dip Switch
T .
Fuse Holder
U .
Electric Power Cord