Fire Burst DMX™
Operation
Fire Burst DMX™
DMX Traits
Channel
Value
Function
1
0 - 255
DIMMING
0% 100%
2 0 - 255 INTERNAL GLASS SPEED
0 STOPPED
1 - 127 CLOCKWISE ROTATION
FAST SLOW
128 STOPPED
129 - 255 COUNTER CLOCWISE ROTATION
SLOW FAST
Master-Slave Operation (Sound Active):
This function will allow
you to link up to 16 units together and operate without a controller. The
units will be sound activated. In Master-Slave operation one unit will
act as the controlling unit and the others will react to the controlling
units programs. Any unit can act as a Master or as a Slave.
1. Using standard XLR microphone cables, daisy chain your units
together via the XLR connector on the rear of the units. Remem-
ber the Male XLR connector is the input and the Female XLR
connector is the output. The first unit in the chain (master) will use
the female XLR connector only - The last unit in the chain will use
the male XLR connector only. For longer cable runs we suggest a
terminator at the last fixture.
2. Follow the dipswitch chart on page 10.
ON
ON
ON
Head 4
1
4
2 3
8
6 7
5
9 10
Head 3
2
1
3 4
6
8
7
9 10
5
Head 2
2
1
3 4
6
8
7
9 10
5
ON
Master-Head 1
1
3
2
4
8
6
5
7
9 10
Master/Slave Chart
American DJ Supply
®
- www.americandj.com - Fire Burst DMX™ Instruction Manual Page 10
American DJ Supply
®
- www.americandj.com - Fire Burst DMX™ Instruction Manual Page 9
This unit comes with a 53.4mm interchangable gobo. Three
dfferent gobos are also included. Changing the gobo is a easy
procedure. Follow the instructions below.
Caution! Never open the unit when in use. Always discon-
nect the main power before attempting to change the gobo.
Caution! Make sure you have given the unit enough time to
cool off, before doing this!
1. Unscrew the two thumb screws located at the bottom rear of
the unit. Slide the bottom of the unit out.
2. When you remove the bottom you will be able to access the
gobo. Unscrew the thumb screw that is located right in front
of the lamp.
3. Using a phillips screwdriver remove the 3 screws and seper-
ate the two pieces of metal that are holding the gobo in
place.
4. Change the gobo, and reassemble the unit.
Fire Burst DMX™ Changing the Gobo
