ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 11
Dotz TPar System System Menu
2. Either “Off” or “On” will be displayed. “Off” the unit will illumi-
nate left to right, and “On” the unit will illuminate right to left. Use
the UP and DOWN buttons to find your desired mode, and press
ENTER.
NO DMX
- This mode can be used as a precaution mode,
that in case the DMX signal is lost, the operating mode
chosen in the setup is the running mode the fixture will go
into when the DMX signal is lost. You can also set this as
the operating mode you would like the unit to return to when
power is applied.
1. Press the MENU button until “NO DMX” is displayed, and either
“Sound”, “Auto”, “Black”, or “Hold” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use
the UP or DOWN buttons to choose an operating mode you
would like the unit to start up in when power is applied or the
DMX signal is lost.
• Sound - If the DMX signal is lost or power is applied, the unit
will automatically go into sound active mode.
• Auto - If the DMX signal is lost or power is applied, the unit will
automatically go into Auto Run mode.
• Black (Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
• Hold - If the DMX signal is lost the fixture will stay in the last
DMX setting. If power is applied and this mode is set, the unit will
automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Personality
- This will let you set your unit as a Master in
a master/slave configuration.
1. Press the MENU button until “Personality” is displayed. Your
ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 10
Dotz TPar System System Menu
unit will now be the Master unit in a Master-Slave configuration.
RF Active
- This menu will let you activate the RF remote
control.
1. Press the MENU button until “RF Active” is displayed, press
ENTER.
2. Either “On” or “Off” will be displayed, use the UP or DOWN
buttons to activate (On) or deactivate (Off) the remote. Press
ENTER to confirm.
