Dotz Flood System Menu
function will also allow you to access Color Mode and Manual
Color Mode.
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. “Show X” will now be displayed, “X” representing a number
between 0-12. Programs 1-12 are factory programs, while “Show
0” is random mode. Press the UP or DOWN buttons to find your
desired show.
Color Mode
- In this mode you can select 1 of 9 static
colors.
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. Press the UP or DOWN buttons so that “Color Mode” is dis-
played, and press ENTER. “Color X” will now be displayed, “X”
representing a number between 1-9. Press the UP or DOWN but-
tons to find your desired color.
3. Press ENTER to select your desired color and then press and
hold the MODE button.
Manual Mode
- In this mode you can adjust the RGB colors
to make your desired color.
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. Press the UP or DOWN buttons so that “Manual Color” is dis-
played, and press ENTER. Either “Red”, “Green”, or “Blue” will
be displayed. Press the UP or DOWN buttons to find color your
would like to adjust, and press ENTER.
3. Use the UP or DOWN buttons to make your adjustment to your
chosen color, and press ENTER when you are finished making
your adjustments.
ADJ Products, LLC - www.adj.com - Dotz Flood User Manual Page 9
Dotz Flood System Menu
DMX Address
-
Set the DMX Address -
1. Press the MENU button until “DMX Addresss” is displayed,
press ENTER.
2. “X” will now be displayed, “X” represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, and then press and hold the MENU
button
for at least three seconds
to assign.
Channel Mode
- This will let you select your desired DMX
Channel mode.
1. Press the MENU button until “Channel Mode” is displayed,
press ENTER.
2. “X Chan” will now be displayed, “X” represents the displayed
DMX channel mode. Press the UP or DOWN buttons to find your
desired Channel mode.
3. Press ENTER to confirm.
Slave Mode
- This will let you set your unit as a master or
slave in a master/slave configuration.
1. Press the MENU button until “Slave Mode” is displayed,
press ENTER. Either “Master”, “Slave 1” or “Slave 2” will be
displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, and press ENTER to confim.
NOTE: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to “Slave 2”, the fixtures
will now have contrast movement to each other.
Show Mode
- Show modes 0-12 (Factory programs). Show
mode can run with or without sound active mode active. This
ADJ Products, LLC - www.adj.com - Dotz Flood User Manual Page 8
