©
American DJ
®
- www.americandj.com - DJ Spot 250™ Instruction Manual Page 11
5-Pin XLR DMX Connectors.
Some manufactures use 5-pin XLR
connectors for DATA transmission in place of 3-pin. 5-pin XLR fixtures
may be implemented in a 3-pin XLR DMX line. When inserting stan-
dard 5-pin XLR connectors in to a 3-pin line a cable adaptor must be
used, these adaptors are readily available at most electric stores. The
chart below details a proper cable conversion.
Conductor
5-Pin XLR Male (In)
3-Pin XLR Female (Out)
Pin 1
Pin 5 - Do Not Use
Pin 4 - Do Not Use
Pin 3
Pin 2
Pin 1
Pin 3
Pin 2
Not Used
Not Used
Data True (+ signal)
Data Compliment (- signal)
Ground/Shield
3-Pin XLR to 5-Pin XLR Conversion
DJ Spot 250™
Set Up
©
American DJ
®
- www.americandj.com - DJ Spot 250™ Instruction Manual Page 12
DJ Spot 250™
System Menu
On-Board System Menu.
The DJ Spot 250™ comes with an easy
to navigate system menu. This next section will detail the functions of
each command in the system menu. You can leave any menu setting
without making any changes by pressing the ESC (ESCAPE) button.
MAIN MENU -
A.001
-
DMX Address Setting
1. Press the ESCAPE button until “
A.001
” is displayed. Press the
ENTER button to adjust the DMX address.
2. Tap the UP or DOWN button until the address that you want
is displayed, press the ENTER button.
TEST
-
This function will activate one of 3 internal test pro-
grams.
1. Press the ESCAPE (ESC) button until “
A.001
” is displayed.
Then press the UP button until “
TEST
” is displayed. Press the
ENTER button to choose a test mode.
2. “
NOD 1
” will now be displayed. Tap the UP button and the dis-
play will go through the modes. Press the ENTER button to
select a mode. Once you select a mode the unit will start the
program. You can now set the speed and fade time of the
program.
3. Tap the UP button and the display will read “
SPEE
” (Speed).
Press the ENTER button to adjust the speed of the pan and
tilt. You can now adjust the speed between 0 - 255, 0 being
the slowest and 255 being the fastest.
4. Once you have chosen your desired speed press ENTER to
select that speed.
5. Tap the UP button and the display will read “
CroS
”. This is
the fade time. Press the ENTER button to adjust the fade
time. You can adjust the fade time between 0 - 255, 0 being