©
American DJ
®
- www.americandj.com - Auto Spot 150™ Instruction Manual Page 8
©
American DJ
®
- www.americandj.com - Auto Spot 150™ Instruction Manual Page 7
Auto Spot 150™
Controls and Functions
REAR
FRONT
1. Lens Assembly -
This high quality lens is a fully focusing. Focus
the lens by manually turning the lens in a clockwise or counter-clock-
wise direction until the desired effect is achieved.
2. XLR DMX Input Jack -
This jack is used to receive an incoming
Auto Spot 150™
Controls and Functions
DMX signal or Master/Slave signal.
3. Cooling Fan -
This unit is equipped with a high velocity variable
fan to aid in the cooling process. This fan is designed to vary its’ veloc-
ity at different operating temperatures, to provide better cooling when
the unit reached higher operating temperatures associated with long
usage. Be sure to never obstruct the cooling fan during normal usage.
Also, be sure to keep this vent clean at all times. A blocked or malfunc-
tioning cooling system may shorten lamp life and unit reliability.
4. XLR Output Jack -
This jack is used to transmit the incoming
DMX signal to another DMX fixture, or transmit a Master/Slave signal
to the next Auto Spot 150™ in the chain. For best results in DMX or
Master/Slave mode terminate this jack if it is the last unit in the chain.
See “Terminator” on page 11.
5. Power Cord Inlet -
This unit is equipped with a removable I.E.C.
power cord. Be sure to only use the power cord included with the unit,
this cord is designed to match the electrical requirements of the unit.
Other cord may cause the unit to overheat or malfunction. Because
Voltage may vary from venue to venue, when connecting this unit to
a power supply be sure to connect to a matching power outlet. Never
use this fixture if the ground prong has been removed or broken off.
The ground prong is designed to reduce the risk of fire or electrical
shock in the event the unit suffers from an internal short.
6. Carrying Handle -
The includes built-in carrying handles. Be sure
to always handle the unit by the built-in handles. Never lift or carrying
the unit by head or yoke. Pulling on or transporting the unit by moving
head may severely damage the unit and will void the unit warranty.
7. Fuse Holder -
This housing stores a 5 amp (3 amp 220v) GMA
protective fuse. Never defeat the fuse, the fuse is designed to protect
the electronics in the event of sever power fluctuations. Always be sure
to replace the fuse with an exact match as to the one being replaced,
unless otherwise told to do so by an authorized American DJ
®
service
technician.
8. Lamp Assembly and Access Plate -
This plate access the lamp
socket assembly. The unit includes a spring mounted LL-HTI150
120v/150w discharge lamp. Be sure to only replace with same type
FUSE
2
7
4
3
1
5
6
MODE
DOWN
UP
ENTER
SOUND
SLAVE
MIC
MIN
MAX.
CONTROL (CA-6)
ONLY FOR REMOTE
SENSITIVITY
DMX
MASTER
8
12
11
13
9
10
14
15
16
17
