RTILT (REVERSE TILT) MENU -
ON/OFF
- When “On” is chosen it will reverse the tilt.
MIC MENU -
MIC
- With this function you can make the internal mic more or
less sensitive to sound.
DISPLAY MENU -
VALU
(DMX-512 Value) - Display the DMX-512 value of each
channel.
D ON
(Display On) - Turns digital display on or off.
FLIP
- “Flips” the digital display 180º.
SPEC MENU -
RDMX
- Lets you adjust the DMX address via external controller.
SPOT
- This provides a spot beam for better lamp optimization.
DFSE
(Default Settings) - Resets the unit to the default settings.
VER
(Version) - Displays the software version
ADJU
- Calibration functions
EDIT MENU -
STEP
(S-01 - S-48) - These are the steps slots that you write
your programs into. There are at total of 48 steps. See edit pro-
gram, page 27.
SCXX
(SC01 - SC30) - These are the scenes that are stored in
your program. There are a total of 30 scenes.
REC
- This will auto save your custom program.
RUN
- This will run your custom program.
Accu Spot 300
System Menu
On-Board System Menu.
The Accu Spot 300 comes with an easy
to navigate system menu. This next section will detail the functions of
each command in the system menu.
Enter Button -
To access the main menu locate the ENTER button
(6)
on the side of the unit. Press this button to activate the system menu.
Tap the UP button
(4)
until you reach function you wish to change.
When you reach the function you wish to change tap the ENTER button
.
When a function is selected the menu will begin to flash, use the
UP
button to change the function. Once your changes are made tap the
ENTER button
again to lock the change in the system, if the ENTER
button
is not selected within eight seconds the system will automati-
cally return to menu section. To exit without making any changes tap
the MODE/ESC button
(3)
.
Accu Spot 300
System Menu
American DJ
®
- www.americandj.com - Accu Spot 300 Instruction Manual Page 16
American DJ
®
- www.americandj.com - Accu Spot 300 Instruction Manual Page 15
ADDR
MAIN MENU -
ADDR
DMX Address Setting
via control board -
1. Access the main menu.
2. Tap the UP button until “
ADDR
” is displayed, press ENTER.
4. Now the display will show “
A001
”. Adjust the DMX address
by pressing the UP or DOWN buttons.
5. Press ENTER to confirm.
6. Press the MODE/ESC button to return to the main menu.
When the display is on
“
A001
”,
you can directly press the UP
or DN buttons to change the DMX start address.
TEST
MAIN MENU -
TEST
- This will test the functions of each channel.
1. Access the main menu.
2. Tap the UP button until “
TEST
” is displayed, press ENTER.
3. The display will show “
T-01
”. You can now press the up
