American DJ
®
- www.americandj.com - Accu Color 250™ Instruction Manual Page 24
American DJ
®
- www.americandj.com - Accu Color 250™ Instruction Manual Page 23
Accu Color 250™
System Menu
3. Tap the UP button until “
LADJ
” is displayed, press ENTER.
4. The display will show “
ON/OFF
”.
5. Press the UP button to select “
ON
” to activate this function,
or “
OFF
” to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
DFSE
- With this function you can restore the factory
settings of the device. All settings will be set back to the
default values. Any edited scenes will be lost. When restor-
ing the factory settings the unit must be set to the address
that the unit was in when you started editing.
1. Access the main menu.
2. Tap the UP button until “
SPEC
” is displayed, press ENTER.
3. Tap the UP button until “
DFSE
” is displayed, press ENTER.
4. The display will show “
ON/OFF
”.
5. Press the UP button to display “
ON
” to activate this function,
or “
OFF
” to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
When you MODE/ESC this function, the unit will begin to
reload data.
VER
- Use this function to display the Software version of
the unit.
1. Access the main menu.
2. Tap the UP button until “
SPEC
” is displayed, press ENTER.
3. Tap the UP button until “
VER
” is displayed, press ENTER.
Accu Color 250™
System Menu
6. Press MODE/ESC to return to the main menu.
To use this function follow the instructions:
To adjust the address of your unit you must first go to the
address that it is currently set to using your DMX Contoller.
From there you can adjust the address, using your DMX Con-
toller. First make sure all channels are set to the value of “0”.
1. On your DMX controller set the DMX value of Channel 1 to
the value “7”.
2. Now set the DMX value of Channel 2 to the value “7” to
adjust the starting address between 1 and 255. To adjust the
address between 256 and 511 set Channel 2 to the value “8” .
3. Set the DMX value of Channel 3 to your desired start-
ing address. This will take about 20 seconds before the unit
accepts the new DMX address.
EXAMPLE:
So, if you want the address to be 57, you must first
set the address that is currently assingned to the unit. The pro-
ceed to set Channel 1s’ value to “7”, Channel 2s’ value to “7”,
and Channel 3s’ value to “57”.
2ND EXAMPLE:
Again, if you want the address to be 420, you
must first set the address that is currently assingned to the unit.
If you want the set the address to 420, set Channel 1s’ value to
“7”, Channel 2s’ value to “8”, and Channel 3s to “164”. (256 +
164 = 420)
SPOT
- With this function you can adjust the lamp via
the control board. The shutter opens and the lamp can be
adjusted. In this mode, the device will not react to any con-
trol signal.
1. Access the main menu.
2. Tap the UP button until “
ADJU
” is displayed, press ENTER.