BASIC OpERATIONS
Figure 6:
tapping the reverse
track button or turning the
track knob counter clockwise
will jump back to the previous
track.
Figure 7:
tapping the forward
track button or turning the
track knob clockwise will skip
forward to the next track.
1. LOADINg/EJECTINg AN SD CARD OR USB DEVICE
The Radius 2000™
can only read SDHC (High Capacity) Cards up to 32GB.
The file format is Mp3 only.
When loading an SD Card into the player load with the SD Card label facing up and the contacts facing down.
To remove the card from the player gently press the card "in" until it "pops' out. When connecting a USB stick,
USB card reader, or external hard drive make sure you are correctly lined up with the USB port and gently insert
the USB connection. To disconnect a USB drive, stop playback and "pull out" the USB connection.
Please
see page 8 for SD Card and USB information.
CAUTION:
•
NEVER
remove a USB device while in PLAY mode.
•
NEVER
remove the SD Card when in PLAY mode.
3. SELECTINg TRACkS
Select a desired track by using either of the two
track ButtonS (17)
or by turning the
track knoB (19)
.
Tapping the
track ButtonS (17)
or turning the
track knoB (19)
once will select either the next higher or
lower track. You may hold down the
track ButtonS (17)
or turn and hold the
track knoB (19)
to change
tracks continuously at a faster speed. If you push the
track knoB (19)
and turn the knob either forward or
reverse you can skip ahead 10 tracks or reverse 10 tracks, at a time.
©
American Audio
®
- www.AmericanAudio.us - Radius 2000™ Instruction Manual Page 18
Figure 5
Figure 6
Figure 7
2.
SELECTING YOUR AUDIO SOURCE - Figure 5
Select your desired audio source using the
Source Selector Button (1)
.
This button lets you toggle
between SD Card slot A, SD Card slot B and the USB port. This selector lets you choose which source
will play on either side. The LED's will verify which source is active. Red LED signifies SD slot A, blue
LED signifies SD slot B, and both red and blue LEDs glowing signifies the USB port. The different
sources can only be selected while in PAUSE mode.
