©American Audio® - www.americanaudio.eu
ELX Series
User Manual Page 20
7.
Slide the coupler (E) along the cable and screw it onto the end of the housing (A). Before tightening, you may want to test the connector to
make sure it has been assembled properly.
7.6
O
PERATING
M
ODES
Always configure your amplifier operating mode before beginning operation. If you want to change it during performance, you must decrease the
gain controls to their lowest levels to protect the speakers from any popping noise.
7.6.1
S
TEREO
O
PERATION
Chapter 7.9 Typical Stereo Output Connections) details an example of a typical stereo set-up.
Connect your inputs into channels one and two of the amplifier.
Connect your speakers to the outputs on the rear of the amplifier. Be sure that your front gain controls are turned down to their lowest level
(full counter-clockwise).
Turn your amp on.
Turn your input source level up. Use your front gain controls to regulate the output volume. Be sure not to raise the volume to the clip level;
however an intermittent clip signal is acceptable.
7.6.2
M
ONO
B
RIDGE
O
PERATION
Chapter 7.10 Typical Mono Bridge Setup details a mono bridge set-up.
Be sure your amplifier and all other audio equipment is powered down.
Flip the Stereo/Bridge switch to the Bridge position.
