©American Audio® - www.americanaudio.eu
ELX Series
User Manual Page 13
(2) Power Switch
– This switch is used to control the units’ main power.
NOTE
: The amp must always be turned
on last
in an audio set up, and turned
off first
in an audio set up. Before powering down the Amp, turn the
gain controls to the lowest position.
(3) Channel B Gain Control
– This rotary knob is used to control the output signal of channel two. Turning the knob in a clockwise direction will
increase signal output. Before powering down the Amp, turn the gain control to the lowest position.
(6) Channel A Gain Control
– This rotary knob is used to control the output signal of channel one. Turning the knob in a clockwise direction will
increase signal output. This gain control is also used when the Amp is in
Bridge Mode
. Before powering down the Amp, turn the gain control to the
lowest position.
(7) Air Inlet
– These air inlets draw in air from the outside to help cool down the amp as it is running. Do not place anything in front or obstruct
these inlets.
Keep these air inlets clean for maximum air flow.
