©American Audio® - www.americanaudio.eu
ELX Series
User Manual Page 17
Strip back the wire insulation 1/2” (13mm).
Insert the bare wire into the hole that was revealed by unscrewing the binding post cap. After inserting the wire into the binding post hole,
screw the binding post cap down on the wire.
Important:
To reduce the risk of shock or damage to your amplifier, be sure that the wire connected to one binding post does not come in contact
with that of another.
Typical speaker output using bare wire.
Insert bare wire into the binding post and tighten.
7.4
M
ONO
B
RIDGE
C
ONNECTIONS
Mono Bridge
operation connections will follow the above descriptions however, when operating in
Mono Bridge
operation the speaker
connections will run between the two positive (red) leads. Use channel two positive output terminal for the negative connection and the channel
one positive output terminal for the positive connection.
7.5
S
TEREO
C
ONNECTIONS
(U
SING THE
N
EUTRIK
S
PEAKON OUTPUT CONNECTORS
)
Recent regulatory requirements in Europe have outlawed the use of the dual banana plug and forced amp users to terminate their speaker cables
with spade lugs or bare wire ends. This is not advantageous to most users that want to reconfigure their systems or quickly change out an amp.
