A6 OPERATING INSTRUCTIONS
05/12/16
4211-146
Page 10 of 11
Mounting the Control
Surface mount the A6 control
inside or outside the steam room using the control
cable installed in section 5, step 4. If mounting to a smooth, flat wall, the adhesive pad
provided will work well to mount the control and seal the cable hole.
The adhesive will
stick to the wall quickly so be sure to accurately place and level the control before
attaching it to the wall!
If the surface is uneven or has grout lines, we recommend using a small amount of
silicone to mount the A6 control. If using silicone, run a bead around the control’s
cable end and another bead around the back of the control as shown here. Then tape
in place on the wall until the silicone has set up.
Note: A cut mark on the back indicates the top of the control
The control’s cable end is at the bottom of the control.
Be sure to carefully level the control while mounting!
Recessed Mounting
The recessed mounting box allows the A6 to mount with its surface almost even to the wall surface.
You’ll need to cut a hole in the wall to match the
back of the mounting box and run the control
cable out of the wall through the hole in the
mounting box. Make sure the hole is just big
enough to mount the box –
you need room
to add silicone to seal the box to the wall.
Next run a bead of silicone around the back
of the box’s front lip, then press the box into
the hole and turn the mounting screws to pull
the tab tight against the inside of the wall.
Make sure the box is level and the correct
end is UP (there is an arrow on the wall side
of the box pointing up).
When the box is ready, run the A6’s cable end
through the cut-out in the adhesive and attach
the adhesive pad to the back of the A6. Be careful –
the adhesive will stick quickly.
Now connect the A6 cable end to the control cable then feed the cables and connector through the hole in the box
and into the wall.
Now test the A6 before mounting it into the wall! Once mounted, the A6 will be hard to remove!
When ready, peel the cover off the back of the adhesive and carefully push the control into the box and hold in
place for about 30 seconds to finish mounting the control. Press the trim ring on to the front of the box and control.
Snap it in place top and bottom and along both sides.
SILICONE
ADHESIVE
OR
UP
PLATED COVER RING
A6
ADHESIVE PAD
MOUNTING BOX
W
A
L
L
