Amel Super Maramu 2000, Owner'S Manual

Page: 122 / 139

128
If necessary, the removal of the AUTOPROP must be done as follow :
- remove the plastic nose cone by removing the screws,
- unscrew the shaft nut locking screw until it is clear of the shaft nut,
- unscrew the shaft nut remembering whether it has a right or left hand thread,
- you can now use your three legged puller to remove your AUTOPROP from the
shaft. With the extractor, screw the extractor plate on to the end of the propeller
boss using the socket head screws provided. Screw in the jacking screw and
tighten until the AUTOPROP loosens on the taper, and remove from the shaft,
-
tape the key onto the shaft, or remove and keep in a safe place.
Reminder : cleaning regularly the propeller’s blades is important to obtain higher efficiency
and avoid higher gas-oil consumption.
About the spare propeller : it must be fitted with all the accessories given (nut and lock
nut).
4.6 Generator
CAUTION ! Read carefully the generator’s manual
before use. It contains warnings concerning your own
safety while operating and doing maintenance.
Any maintenance work on mechanical or electrical parts
of the generator should be done by skilled workers,
using appropriate tools and protections.
The very hot oil of the cover may causes some severe
burns on the skin. Wear adapted equipment, protecting
the whole body.
4.6.1 Fluids
a) Oil
There are 2 different holes for the oil refill. Both can be used. To change the oil, remove the
cap of the blue hose, and introduce it into a jerrycan. The gravity drain goes easier if the
engine is heaten (be careful : oil projections can cause severe damages. Wear special
equipment.
During the oil changing, replace the oil filter too.
To know the maintenance occurrences, and the way to do it, refer to the manufacturer’s
manual, section “Maintenance”.
Environment protection : wasted oil must be collected separately. Give it to an agreed
company.