Amel Super Maramu 2000, Owner'S Manual

Page: 118 / 139

124
Pict. 129 – Aft lift U-bolt
Remark : the boat can be lift with adapted straps under the hull.
Take care not to damage the propelling system and the rudder, like the electronic sensors
(depth-sounder and Sonic Speed, …).
‚ switch off all the electric power supply (especially the bow thruster and the main
engine start).
ƒ switch off the bilge pump,
„ clean with non-abrasive sponge and fresh water (if necessary with soapy water)
all the parts, seacocks and appendixes of the boat’s hull.
let dry.
To maintain the hull below the floating waterline :
 put the boat out of the water.
‚ switch off all the electric power supply (especially the bow thruster).
ƒ switch off the bilge pump.
„ clean with non-abrasive sponge and fresh water (if necessary with soapy water)
all the parts, seacocks and appendixes of the boat’s hull :
-
ballast,
- skeg,
- rudder,
-
propeller shaft,
-
ground plates,
- sacrificial zinc anodes (if they have been changed this year),
- Sonic Speed,
- seacocks and scuppers.
if some shells are stay on the hull, don’t use the high pressure machine but a
spatula.
† release the sacrificial zinc anodes, and replace by an equivalent model ; if they
are not eaten away, check the electrical continuity.
‡
apply an hard antifouling painting system (not a eroding one) on the hull and the
bow thruster’s foot. Don’t paint :